|15th floor,rongchao mansion,longcheng street,longgang,shenzhen,email@example.com|
Payment & Shipping Terms:
|Water Absorption:||0.49%||Dielectric Loss:||0.008|
|Working Temperature:||90℃||Emergency Overload:||130℃|
|Tensile Strength:||1.16MPa||Ultimate Elongation:||850%|
COTRAN NO.KC80 Waterseal Mastic Tape / Water seal Mastic Tape / Tape No.KC80 / water proof tape / water seal tape / Rubber Mastic Tape:
COTRAN NO.KC80 waterseal Mastic Tape - Applications:
1, Use for insulation, filling and moisture sealing in splies of all types of power cables and optical telecommunication cables. For PRIMARY INSULATION UP TO 1000 VOLTS.
2, Use for insulating and moisture sealing on bus bar.
3, Use for moisture sealing high or low voltage junction boxes and irregular splices.
Size: 51mm x 1.65mm x 3m (2in x 0.065in x 10ft)
COTRAN NO.KC80 waterseal Mastic Tape - Instruction:
1, Wipe off the dusts on the splice area before wrapping.
2, Remove the liner and stretch the tape to 1 to 2 times of its original length.
Apply the tape in 50%-lapped with mastic side toward area to be wrapped.
Stretching the tape to 4 times of its original length is not recommended.
3, Be sure to extend wrapping 30mm to 50mm up onto the cable jacket on both sides of the splice area.
4, After KC80 waterseal mastic tape is applied, overwrapping COTRAN PVC insulation tape is recommended. Apply 3 layers of COTRAN PVC insulation tape in a 50% overlapping with no tension. Make sure not to overstretch the PVC tape during application.
|Mechanical performance||Typical value||Testing method|
|Thickness||1.75mm||ASTM D 4325|
|Tensile Strength||1.16MPa||ASTM D 4325|
|Ultimate Elongation||850%||ASTM D 4325|
|Dielectric intesity||22.5KV/mm||ASTM D 4325|
ASTM D 1000
ASTM D 1000
|Melting point||A grade pass||ASTM D 4388|
|Dielectric loss||0.008||ASTM D 4325|
|Working Temperature||90℃||ASTM D 4388|
|Emergency overload||130℃||ASTM D 4388|
|Water absorption||0.49%||ASTM D 570|
|Water vapour percolation rate||<0.26g/(100inch 2.24h)||ASTM D 3833|
|Ozone resistance test||pass||ASTM D 4388|
|Heat exposure||130℃||ASTM D 4388|
|UV resistance||pass||ASTM D 4388|
Contact Person: ruby